What liquid do you use for hydro dipping?

What products do you need to Hydro dip?

Step-By-Step Guide to Hydro Dipping
  • Large, deep plastic container (the container will have paint on the inside after the hydro dipping is complete)
  • DIY complete hydrographic printing kit.
  • Object to be dipped.
  • Sandpaper to smooth the surface.
  • Rags.
  • Bucket of mild cleaning solution and water.
  • Vinyl, rubber, or latex gloves.

What type of water do you use to hydro dip?

Make sure all of the items you will need are within arm’s reach, as the process of hydro dipping can go very quickly. Fill your container about ¾ full with lukewarm or warm water, as the ideal temperature for spray paint is between 50 and 90 degrees Fahrenheit (approximately 10 to 32 degrees Celsius).

Do you need activator to Hydro dip?

Under and over activating are two of the leading causes in problems with hydro dipping. You are not applying a layer of paint, you just need enough activator (with a fine mist, fan pattern spray) to cover the film lightly.

Do you need a base coat for hydro dipping?

Choosing the right base coat color is very important in hydro dipping. … So if you are wanting the design to look as intended and usually shown on the product page of where you are purchasing the film, then using a white base coat is usually the best choice unless it is specified that another color was used in the photo.

Does Hydro dipping with spray paint last?

Hydrographic finishes are very robust and will last for many years under normal use. However, similar to your car finish, the paint can scratch if the product is abused. Scratching the protective clear coat can cause failure to the hydrographic finish.

What do you need for hydro dipping with spray paint?

You can hydro dip any item with a nonporous surface — all you need are a few simple supplies!
  1. A tote to hold water (size depends on size of object dipping)
  2. 2X Rust-Oleum Spray Paint and Primer.
  3. Your choice of what to Hydro Dip.
  4. Latex gloves.
  5. Paint stirring stick.

How do you prepare plastic for hydro dipping?

It’s not quite as harsh. So it doesn’t really get into the plastic. And very well and it doesn’t